Table of Contents
Advertisement
Select Enabled if your system has a floppy disk controller (FDD) installed on the system board and
you wish to use it. If you install add-on FDC or the system has no floppy drive, select Disabled in this
field. The settings are: Enabled and Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and the second serial ports. The settings
are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART2 Mode
This item allows you to determine which Infrared (IR) function of the onboard I/O chip to be used.
Onboard Parallel Port
There is a built-in parallel port on the onboard Super I/O chipset providing Standard, ECP, and EPP
features. It has the following option:
Disabled
(3BCH/IRQ7)/
(278H/IRQ5)/
(378H/IRQ7)
Parallel Port Mode
SPP
: Standard Parallel Port
EPP
: Enhanced Parallel Port
ECP
: Extended Capability Port
SPP/EPP/ECP/ECP+EPP
To operate the onboard parallel port as Standard Parallel Port only, choose "SPP." To operate the
onboard parallel port in the EPP modes, choose "EPP." By choosing "ECP", the onboard parallel
port will operate in ECP mode only. Choosing "ECP+EPP" will allow the onboard parallel port
to support both the ECP and EPP modes simultaneously. The ECP mode requires the use of
DMA channel. So, after selecting ECP mode, the message: "ECP Mode Use DMA" will be
displayed at this time. The user can choose among DMA channels 3 to 1. The onboard parallel
port is EPP compliant. So, after you choose the onboard parallel port with the EPP function, the
message: "EPP Mode Select" will be displayed on the screen. At this time either EPP 1.7 spec.
or EPP 1.9 spec. can be chosen.
3-8 Power Management Setup
The Power Management Setup allows you to configure the system to most effective energy
saving status in a manner consistent with your own style of computer use.
CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
ACPI Function
ACPI Suspend Type
Video off Method
Power Button Function
Wake-Up on PCI PME
Wake-Up on Ring/LAN
USB Resume from S3/S4
Wake Up on RTC Alarm
X Time(dd:hh:mm) of Alarm
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
ACPI Function
Line Printer port 0
Line Printer port 2
Line Printer port 1
Power Management Setup
Enabled
S1(POS)
V/H SYNC+Blank
Instant-Off
Disabled
Disabled
Disabled
Disabled
0: 0: 0
F6:Optimized Defaults
Menu Level >
F7:Standard Defaults
28
Item Help
F1:General Help
Advertisement
Table of Contents
