Irq Resources - JETWAY N2PA-LITE User Manual

Normally, this field is set Disabled. If you have installed a new add-on and the system
reconfiguration has caused a serious conflict resulting in the operating system boot failure,
select Enabled to reset Extended System Configuration Data (ESCD) when you exit Setup. The
settings are: Enabled and Disabled.
Resource Controlled By
The Award Plug and Play BIOS has the capability to configure all of the boot and Plug and
Play compatible devices automatically. However, this capability means absolutely nothing
unless you are using a Plug and Play operating system, such as Windows  95/98. If you set
this field to "manual", choose specific resources by going into each of the sub menu that
follows this field (a sub menu is preceded by a ">").
The settings are: Auto(ESCD), Manual.

IRQ Resources

When resources are controlled manually, assign each system interrupt a type, depending on
the type of device using the interrupt.
Please refer to section 3-9-1
PCI/VGA Palette Snoop
Leave this field at Disabled. The settings are Enabled, Disabled.
3-9-1 IRQ Resources
CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
IRQ3 assigned to
IRQ4 assigned to
IRQ5 assigned to
IRQ7 assigned to
IRQ9 assigned to
IRQ10 assigned to
IRQ11 assigned to
IRQ12 assigned to
IRQ14 assigned to
IRQ15 assigned to
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
IRQ Resources
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
F6:Optimized Defaults
30
Item Help
Menu Level >>
F1:General Help
F7:Standard Defaults