Starting Up Your Computer - JETWAY N2PA-LITE User Manual

2-7 Starting Up Your Computer

1. After all connections are made, close your computer case cover.
2. Be sure all the switches are off and the power supply input voltage is set to proper
position. The input voltage is either 220V∼240V or 110V∼120V depending on your
country's power voltage.
3. Plug the power supply cord into the power socket located on the back of your system case
according to your system user's manual.
4. Turn on your peripherals in following order:
a. Your monitor.
b. Other external peripherals (Printer, Scanner, External Modem etc...)
c. Your system power. For ATX power supply, you need to turn on the power supply
and press the ATX power switch on the front panel of the case.
5. The power LED on the system front panel will light. The LED on the monitor may light
up or switch between orange and green (if it complies with green standards or has a power
standby feature) after the system is on. The system will then run power-on self test and
the BIOS will beep with additional message on the screen.
If you do not see any thing on the screen within 30 seconds from the time you turn on the
power. The system may have failed on power-on test. Recheck your jumper settings and
connections or call your dealer or shop for assistance.
Beep
One short beep when displaying logo
Long beeps in an endless loop
One long beep followed by three short
beeps
High frequency beeps when system is
working
6. During power-on, press <Delete> key to enter BIOS setup.
instructions to set up BIOS.
7. Power off your computer: You must first exit or shut down your operating system
before switching off the system. For ATX power supply, you can press ATX power
switch after exiting or shutting down your operating system. If you use Windows 9X,
click "Start" button, click "Shut down" and then click "Shut down the computer?"
The power supply should turn off after windows shut down.
Meaning
No error during POST
No DRAM install or detected
Video card not found or video card memory
bad
CPU overheated
System running at a lower frequency
18
Follow the on screen