Table of Contents
Advertisement
(8)
Wake On-LAN Headers (3-pin) : WOL
This connector connects to LAN card with WAKE ON-LAN output. When connected,
a wake up signal received through the LAN card will power up the system.
NOTE: This feature requires the Wake On LAN or Ring In Wake Up be enabled.
(9) FAN Speed Headers (3-pin) : SFAN1, SFAN2, CPUFAN
These connectors support a ≦ 350mA (4.2 Watts) current to cooling fans. Depending on
the fan manufacturer, the wire and plug may be different. The red wire should be
positive, while the black should be ground. Make sure the polarity of connector before
you connect the fan's plug to the board.
(10) IR infrared module Headers (5-pin) : IR
This connector supports the optional wireless transmitting and receiving infrared
module. You must configure the setting through the BIOS setup to use the IR function.
WOL
1
3
Wake-On-LAN Headers
1
3
CPUFAN
3
1
SFAN1
3
1
SFAN2
16
Advertisement
Table of Contents
