Table of Contents
Advertisement
power button will be locked up. You must turn off and turn on the AC power to
reset the system. Otherwise, the power button will not function. The other way is
to keep pressing the button for a few seconds till the beep sound stops. Then,
release the power button and press the power button again to turn on the power
supply.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF socket and
open it by first pulling the lever sideways away from the socket and lift the lever upward to a
90-degree angle. Insert the CPU with the correct orientation as shown below. The notched
corner should be pointed toward the end of the lever. The CPU has corner pin on two of the
four corners and the CPU will only fit in the orientation as shown.
When you insert the CPU onto the ZIF socket, no force is required. After inserting, press the
lever slightly without any extra force to lock CPU in position.
2-4 Install Memory
This motherboard provides two 184-pin DUAL INLINE MEMORY MODULES (DIMM)
sockets for memory expansion from a minimum memory size of 64MB to maximum memory
size of 2.0GB DDR SDRAM.
Valid Memory Configurations
Bank
Bank 0, 1 (DIMM1) DDR 266/333/400 DDR SDRAM
Bank 2, 3 (DIMM2) DDR 266/333/400 DDR SDRAM
Total
NOTE! Make sure the total installed memory size does not exceeds 2.0GB. Otherwise,
the system may hang during startup.
Generally, installing DDR SDRAM modules to the motherboard is very straightforward.
Please refer to figure 2-4 for the detail of 184-Pin
and the socket.
Socket 462
CPU ZIF Socket-A
184-Pin DIMM
System Memory (Max. 2.0GB)
Colden Arrow
PCS
DDR 266/333/400
9
Total Memory
X1
64MB∼1.0GB
X1
64MB∼1.0GB
2
64MB∼2.0GB
DDR SDRAM module
Advertisement
Table of Contents
