Pnp/Pci Configuration Setup - JETWAY N2PA-LITE User Manual

This item allows you to Enabled/Disabled the Advanced Configuration and Power Management
(ACPI). The settings are Enabled and Disabled.
Video Off Method
This determines the manner in which the monitor is blanked.
DPMS (default)
Blank Screen
V/H SYNC+Blank
Power Button Function
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state.
The settings are: Delay 4 Sec, Instant-Off.
Wake Up On Ring/PME/LAN
When Disabled, the system will ignore any incoming call from the modem/LAN. When Enabled,
the system will boot up if there's an incoming call from the modem.
Wake Up on RTC Alarm
This function is for setting date and time for your computer to boot up. When Disabled, you
cannot use this function. When Enabled, choose the Date and Time Alarm:
Time(dd:hh:mm) of Alarm
You can choose at which day of month , what hour and minute the system boots up.
Note: If you have changed the setting, you must reboot system to make this function work.

3-9 PnP/PCI Configuration Setup

This section describes how to configure the PCI bus system. PCI, or Personal Computer
Interconnect, is a system which allows I/O devices to operate at speeds similar to the speeds
CPU uses when communicating with its own special components. The setup involves
extensive technical knowledge. It is strongly recommended that only experienced users should
make any changes to the default settings.
CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
Reset Configuration Data
Resources Controlled By
x IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Reset Configuration Data
Initial display power management signaling.
This option only writes blanks to the video buffer.
This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
PnP/PCI Configurations
Disabled
Manual
Press Enter
Disabled
Enabled
Enabled
F6:Optimized Defaults
29
Item Help
Menu Level >
F1:General Help
F7:Standard Defaults