Shock Sensor (Alarm Models) - Ultra Start 3295Series Installation Manual

95 SERIES
INSTALL MANUAL
ALARM MODELS ONLY
THE SHOCK SENSOR SENSITIVITY IS SET USING THE REMOTE PROGRAM MODE
FEATURE. ALARM MODELS ONLY.
ENTER REMOTE PROGRAM MODE
M-1234
PROGRAM
ENTER SHOCK SENSITIVITY PROGRAMMING
1 OFF
SEN 5
ADJUSTING THE SENSOR SENSITIVITY
1 OFF
SEN 3
OFF
1
SEN 7
EXIT PROGRAM MODE
PRESS AND RELEASE THE STATUS BUTTON ON THE REMOTE TO EXIT.
NOTE- If the system has been triggered (shock sensor, door input..), the siren will sound for approximately
60 seconds. Press and release the lock or unlock button to silence the siren (the system will remain armed).
Press the unlock button to disarm the system. The siren and park lights will flash three times to indicate the
system had been triggered.
TO ENTER PROGRAM MODE
PRESS AND HOLD THE STATUS BUTTON ON THE
REMOTE FOR 4 SECONDS.
THE REMOTE WILL BEEP 1 TIME AND THEN 3 TIMES.
THE DISPLAY WILL SHOW "PROGRAM" & "M-1234"
PRESS AND RELEASE THE UNLOCK BUTTON
THE SENS LEVEL WILL BE DISPLAYED
PRESS AND RELEASE THE UNLOCK BUTTON TO
DECREASE THE SENSITIVITY. THE LCD WILL SHOW
THE CURRENT SETTING. THE LOWEST (LEAST
SENSITIVE SETTING IS SEN 1.
PRESS AND RELEASE THE START BUTTON TO
INCREASE THE SENSITIVITY. THE LCD WILL SHOW
THE CURRENT SETTING. THE HIGHEST (MOST
SENSITIVE) SETTING IS SEN 10.
SYSTEM PROGRAMMING - Menu 1
SHOCK SENSOR SETTINGS
PAGE 26