Sign in today to find solutions:

Don't have an account? Sign up

Ultra Start 1150 Series Install Manual

Ultra start - applicated security technologies remote starters install guide.

 
INSTALL GUIDE
U.S.A. Model
1150 Series Remote Starters
REMOTE STARTERS
CAR ALARMS
ü
WWW.ULTRASTARTERS.COM
-The system must be placed into Service Mode before any service work is started on
the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done.
The manufacturer accepts no liability or responsibility for accidental starting of the
vehicle.
- CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)
Next page ->

Summary of Contents

  • Page 1

    INSTALL GUIDE U.S.A. Model 1150 Series Remote Starters REMOTE STARTERS CAR ALARMS ü WWW.ULTRASTARTERS.COM -The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done.

  • Page 2

    INSTALLATION MANUAL Page 2 Components - Control module - 6 pin main harness with dual 30amp power inputs - 2 Pin keyless entry harness - LED/Program Switch Diagnostics PARK LIGHTS 3 Slow Flashes 5 Flashes 5 Slow Flashes 6 Flashes 7 Flashes 8 Flashes Diagnostic Memory- With Program LED/Switch.

  • Page 3

    REMOTE VEHICLE STARTER Not used on this model Negative When Running Not used on this model Positive Start Trigger* Negative Start Trigger* * Connect only one of these wires for remote start activation. The input requires 2 pulses within 2 seconds to activate. Program LED/Switch The jumpers control the output from the white wire from the six pin harness.

  • Page 4

    INSTALLATION MANUAL Page 4 WIRING CONNECTIONS 6 Pin Power Connector Yellow Starter Green Heater 12 power 12 power Blue Ignition 1 White Select Output 14 Pin Connector Yellow Re-Arm Red/White Brown Disarm Orange (-) Output White/Blue Horn Black/White Purple (+) Start White Park Lights Green/White...

  • Page 5

    REMOTE VEHICLE STARTER QUICK START INSTALL Step 1 - Connect All Of the Following Wires 6 Pin Power Connector Yellow Starter Output Green Heater Output 12 power Input 12 power Input Blue Ignition 1 Output White Selectable Output 14 Pin Power Connector Black System Ground Pink...

  • Page 6

    INSTALLATION MANUAL Page 6 Programming Overview Program mode allows you to adjust the settings and options of your system. Your system has been intelligently designed by installers with years of experience. The system’s default settings do not require any program changes in most cases. However, this system does incorporate a highly advanced programming system that can be easily adjusted for custom installations and applications.

  • Page 7

    REMOTE VEHICLE STARTER Programming Menu Turn the ignition key to the on position 3 times then press and release the program button. The park lights will turn on and the horn(Optional) will honk once. While the park lights are on press and release the program button until the LED is flashing the same number of times as the program setting that is to be changed.

  • Page 8

    INSTALLATION MANUAL Page 8 See page 6 for Entering Program Mode. Setting 5-Maximum Crank Time 1 10 Seconds 1 Flash 2 3 Seconds 2 Flashes 3*5 seconds 3 Flashes Press the Program Button 5 times to select setting 5 (This will be confirmed by 5 LED flashes) Press and hold the Program Button until you receive the appropriate # of park light flashes and/or horn honks.

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: