Shock Sensor Programming (Alarm Models) - Ultra Start 90 Series Owner's Manual

90 & 95 SERIES
OWNER'S MANUAL
SHOCK SENSOR ADJUSTMENTS (2WAY ALARM MODELS)
THE SHOCK SENSOR SENSITIVITY IS SET USING THE REMOTE PROGRAM MODE
FEATURE. ALARM MODELS ONLY.
ENTER REMOTE PROGRAM MODE
M-1234
PROGRAM
ENTER SHOCK SENSITIVITY PROGRAMMING
1 OFF
SEN 5
ADJUSTING THE SENSOR SENSITIVITY
1 OFF
SEN 3
1 OFF
SEN 7
EXIT PROGRAM MODE
PRESS AND RELEASE THE # BUTTON ON THE REMOTE TO EXIT.
TO ENTER PROGRAM MODE
PRESS AND HOLD THE # BUTTON ON THE
REMOTE FOR 4 SECONDS.
THE REMOTE WILL BEEP 1 TIME AND THEN 3 TIMES.
THE DISPLAY WILL SHOW "PROGRAM" & "M-1234"
PRESS AND RELEASE THE UNLOCK BUTTON AND
THE SENS LEVEL WILL BE DISPLAYED
PRESS AND RELEASE THE UNLOCK BUTTON TO
DECREASE THE SENSITIVITY. THE LCD WILL SHOW
THE CURRENT SETTING. THE LOWEST (LEAST
SENSITIVE SETTING IS SEN 1.
PRESS AND RELEASE THE START BUTTON TO
INCREASE THE SENSITIVITY. THE LCD WILL SHOW
THE CURRENT SETTING. THE HIGHEST (MOST
SENSITIVE) SETTING IS SEN 10.
SYSTEM PROGRAMMING - Menu 1
SYSTEM OPERATIONS
PAGE 20