Shock Sensor Programming/Adjustment - Ultra Start 25 SERIES Owner's Manual

REMOTE VEHICLE STARTER
Button 4(#) - Optional operations(Dealer programmable feature)
Car Finder (Default Setting)
1. Press and hold the # button for 3 seconds.
2.The park lights will flash and the horn(optional) will honk 5 times.
Note: This feature can be used to locate the vehicle in a crowded parking lot.
Trunk Release on the # button.
1. Press and hold the # button for 3 seconds. The park lights will flash and the
horn (optional) will honk once. Continue holding the unlock button until the
trunk release activates.
Garage Door Activation (Requires Garage Door Interface)
1. Press and hold the # button for 3 seconds. The optional garage door
interface will activate.
* The system will have no conformation for Garage Door Activation.

Shock Sensor Programming/Adjustment

To Enter Shock Sensor Programming
Method 1
Method 1 - Press & Release the LOCK button 5 times (once every one
5 times
Method 2 - Press & Hold the LOCK & UNLOCK buttons for 3 seconds.
While the park lights are on strike the vehicle with the amount of force
wanted to trigger the alarm*. Strike the vehicle the same amount of force
Method 2
3 times. The siren will chirp each time the system detects impact.
* Strike the vehicle with the palm of the hand, be careful not to impact
Press UNLOCK to exit shock sensor programming.
Temporary Shock Sensor Bypass
1st
1. Press and Release the LOCK button(to arm system).
2. Press and Release
2nd
The system will chirp once to arm and once again to confirm
Temporary Shock Sensor Bypass.
second). The Siren will chirp 3 times and the park lights will stay on.
The siren will chirp 3 times and the park lights will stay on.
the vehicle in an area that may cause damage. The most common
location for testing and setting the shock sensor is the A-pillar.
The A-pillar is the metal support that runs from the roof of the vehicle
to the hood area. Avoid hitting the windshield when programming.
OWNER'S GUIDE
button (within 3 seconds).
Page 7