Ultra Start 3295Series Installation Manual page 14

95 SERIES
INSTALL MANUAL
4 PIN AUXILIARY SENSOR CONNECTOR*
*ALARM MODELS ONLY
1- BLUE Pre-Warn Trigger (-) Input
When this wire is grounded by an auxiliary sensor (i.e: Radar Sensor) the system will chirp the SIREN 3 times.
2- GREEN Full Alarm Trigger (-) Input
When this wire is grounded by an auxiliary sensor (i.e: Radar Sensor) the alarm will activate for up to 60 sec.
3- BLACK Sensor Ground Output (-)
This wire provides a ground output for the auxiliary sensor.
4- RED Sensor 12volt Output (+)
This wire provides a 12volt output for the auxiliary sensor.
3 PIN BYPASS CONNECTOR
1- WHITE/VIOLET Wire-Ground When Running (-)
Connect this wire to the your bypass modules negative turn on wire. When the remote starter is activated
this wire will switch to ground.
2- BLACK Wire- System Ground (-)
Connect this wire to the ground input on the bypass module.
3- RED Wire- 12volt Power Input (+)
Connect this wire the 12volt input on the bypass module.
4 PIN DATA BYPASS
The default setting is for idatalink modules. For Fortin bypass modules power-
up the system with the Fortin module connected to the data port to set the default
to Fortin bypass module.
2 PIN THERMISTOR/ START TRIGGER
The thermistor can be installed in the engine compartment for engine temperature or in
under the dash for interior temperature.
PRE-WARN TRIGGER
FULL TRIGGER INPUT
GROUND OUTPUT FOR AUXILIARY SENSOR
12VOLT OUTPUT FOR AUXILIARY SENSOR
GROUND WHEN RUNNING OUTPUT
SYSTEM CHASSIS GROUND INPUT
CONSTANT 12 VOLT INPUT (20AMP)
SYSTEM PROGRAMMING - Menu 1
SYSTEM WIRING DETAILS
WHITE/VIOLET
PAGE 14
BLUE
GREEN
BLACK
RED
BLACK
RED