Program Menus - Ultra Start 3295Series Installation Manual

PAGE 15
PROGRAM MODE
SYSTEM PROGRAMMING - Menu 1
ENTERING PROGRAM MODE
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and release the Program Switch 1 time. (The park lights will turn on and the HORN will chip to
confirm that program mode was entered)
3 - Select the Program Menu by pressing...
Press Lock
MENU 1
SELECT AND CHANGE
4 - Press and Release the Program Switch to advance through the settings.
(Confirmed by HORN/ SIREN chirps & LED flashes)
5 - Press and hold the Program Switch to change the setting.
(Confirmed by HORN/ SIREN Chirps)
6 - To exit Program Mode, turn key off.
(Confirmed by Long HORN/ SIREN Chirp)
SYSTEM RESET
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and RELEASE the Program Switch 1 time.
(HORN/ SIREN will chip to confirm that program mode was entered)
3 - Press and HOLD the Program Switch for until the HORN/SIREN Chirps 3 times.
4 - Turn ignition key OFF to exit.
TRANSMITTER PROGRAMMING
1 - Cycle the Ignition Key On/Off On/Off On. (Leaving the key ON)
2) Press and HOLD the Program Switch.
(The HORN/ SIREN will chirp 1 time, CONTINUE to HOLD)
**If the HORN/ SIREN does not chirp turn the key off, then repeat step 1**
3) Continue to HOLD the Program Switch and the HORN/ SIREN will chirp 5 times.
4) Press the LOCK BUTTON on each of remote's to be programmed.
*Pause for about 1 second between programming of each remote.
System can accept 4 remote's max.
5) The park lights will flash once and the HORN/SIREN will chirp once each time a new code is learned.
6) Release the Program switch and turn Ignition OFF.
Press Unlock
MENU 2
Press Start
MENU 3
95 SERIES
INSTALL MANUAL
Press Status
MENU 4