Ultra Start 3295Series Installation Manual page 23

PAGE 23
PROGRAM MODE
SYSTEM PROGRAMMING - Menu 1
PROGRAM MODE 4
SETTING 2-ADJUST FOR UNDER-CRANK
THE SIREN WILL CHIRP 2 TIMES WHEN SETTING 2 IS SELECTED
CHANGE SETTING 2 -
GOTO SETTING 3 - PRESS & RELEASE THE VALET SWITCH
1 CHIRP 1 CHIRP
SETTING 3-ADJUST FOR OVER-CRANK
THE SIREN WILL CHIRP 3 TIMES WHEN SETTING 3 IS SELECTED
CHANGE SETTING 3 -
GOTO SETTING 4 - PRESS & RELEASE THE VALET SWITCH
1 CHIRP 1 CHIRP
SETTING 4- TACH WAIT
THE SIREN WILL CHIRP 4 TIMES WHEN SETTING 4 IS SELECTED
CHANGE SETTING 4 -
GOTO SETTING 5 - PRESS & RELEASE THE VALET SWITCH
1 CHIRP 1 CHIRP
2 CHIRP 2 CHIRP
3 CHIRP 3 CHIRP
SETTING 5- BYPASS SELECTION
THE SIREN WILL CHIRP 5 TIMES WHEN SETTING 7 IS SELECTED
CHANGE SETTING 5 -
GOTO SETTING 1 - PRESS & RELEASE THE VALET SWITCH
1 CHIRP
2 CHIRP
TIP- FOR FORTIN BYPASS MODULES CONNECT THE POWER TO THE REMOTE STARTER WITH THE BYPASS
MODULE CONNECTED TO SET FOR FORTIN.
PRESS & HOLD THE VALET SWITCH UNTIL THE SIREN CHIRP(S)
Each time the HORN/ SIREN chirps the Tach setting is reduced by 10%
PRESS & HOLD THE VALET SWITCH UNTIL THE SIREN CHIRP(S)
Each time the HORN/ SIREN chirps the Tach setting is increased by 10%
PRESS & HOLD THE VALET SWITCH UNTIL THE SIREN CHIRP(S)
SETS OPTION 1 – 300ms- The system will wait 300ms before starting to monitor the
Tach input.
SETS OPTION 2 – 750ms- The system will wait 750ms before starting to monitor the
Tach input.
SETS OPTION 3 – NO WAIT- The system will monitor the Tach as soon as the
vehicle has remote started. (DEFAULT)
PRESS & HOLD THE VALET SWITCH UNTIL THE SIREN CHIRP(S)
SETS OPTION 1 –FORTIN- Operation of Fortin bypass modules.
SETS OPTION 2 – IDATA- Operation of IDATA bypass modules.
SYSTEM PROGRAMMING - Menu 1
PRESS
2 CHIRP
1 TIME
PRESS
3 CHIRP
1 TIME
PRESS
4 CHIRP
1 TIME
PRESS
5 CHIRP
1 TIME
95 SERIES
INSTALL MANUAL
2X
3X
4X
5X