Anti-Tip Device; Adjusting The Height Of The Anti-Tipper; Activating And Deactivating The Anti-Tip Device - Invacare Rea Dahlia 30 User Manual

1. Remove the telescopic rearwheel shaft G.
2. Pull the quick release knob F outwards to release the
wheel.
3. Remove the rearwheel.
4. Repeat the procedure on the opposite side.

3.11 Anti-tip device

3.11.1 Adjusting the height of the anti-tipper

A
1. For height adjustment of the anti-tipper, press the
spring-loaded button A.
2. Adjust the anti-tipper B to the desired height.
3. Make sure that the spring-loaded button A pops out
into place in its new position again after adjustment.
WARNING!
Risk of tipping
– Maximum height from floor to anti-tipper
is 40 mm. Minimum height from floor to
anti-tipper is 15 mm.
1572307-J
B
The anti-tipper has seven possible height positions.
WARNING!
Risk of tipping
Insufficient support from the anti-tippers
– Be careful when using the anti-tippers when
propelling on soft areas such as lawns. The
anti-tippers might sink into the ground.
IMPORTANT!
Risk of damage
– Never step on the anti-tipper or use it as a
tipping aid.
3.11.2 Activating and deactivating the anti-tip
device
1. For transport position, use your foot to press the lower
part B of the anti-tip device A and fold it inwards.
2. Repeat the procedure on the opposite side.
WARNING!
Risk of tipping
The wheelchair can tip backwards if the anti-tip
devices are not activated.
– Do not forget to activate the anti-tip devices
after transport.
Product Overview
A
B
19