Removing/Installing/Adjusting The Back Cane Bracket - Invacare Action 5 Service Manual

Removing/Installing/Adjusting the Back-Cane
Bracket
NOTE: For this procedure, refer to FIGURE 4.8.
NOTE: To install the back-cane bracket, reverse this procedure.
1. Remove the back canes. Refer to Removing Back-Canes paragraph.
2. Pull up on the seat upholstery.
3. Unscrew the two mounting screws (M6) with T30 Torx key that secure the back-cane
bracket to the wheelchair frame.
4. Do one of the following:
• To Remove:
1) Remove the mounting screw (T25 Torx key) that secures the reflective cap on the back
of the seat rails
2) Remove the back-cane bracket by sliding it off the back of the wheelchair frame.
• To Adjust:
1) Slide the back-cane bracket to the desired position to the wheelchair frame.
2) Tighten (12-14 Nm) the two mounting screws (M6) with T30 Torx key that secure the
back-cane bracket on the frame.
NOTE: Both back-canes bracket should be set to the same position.
Mounting screws
(M6)
FIGURE 4.8 Removing/Installing/Adjusting the Back-Cane Bracket
Mounting screw
(M5)
Reflective cap
2 1
SECTION 4—SEAT/BACK
Back-cane
bracket