Section 7-Rear Wheels; Removing/Installing The Rear Wheels; Permanent Axles - Invacare 9000 Jymni Pediatric Series Maintenance Manual

SECTION 7—REAR WHEELS
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.

Removing/Installing the Rear Wheels

If changing the size of the rear wheel or a change in the seat-to-floor height is
desired, this procedure must be performed by a qualified technician.

Permanent Axles

NOTE: For this procedure, refer to FIGURE 7.1.
NOTE: If replacing the same size rear wheel, note the mounting position on the wheelchair frame
for proper reinstallation of the new rear wheel.
1. Remove the dust cap (if applicable), mounting screw and locknut that secure the rear
wheel and axle spacer to the wheelchair.
2. Repeat STEP 1 for the opposite rear wheel.
3. To reinstall the rear wheel onto the wheelchair, reverse STEPS 1-2.
Rear Wheel
Dust Cap
FIGURE 7.1 Removing/Installing the Rear Wheels - Permanent Axles
Part No 1100868
WARNING
WARNING
Wheelchair Frame
Axle Mounting Positions
Mounting Screw
SECTION 7—REAR WHEELS
Axle Spacer
45
Lock Nut
9000 Jymni™Pediatric Series