Changing Wheel Lock Handle Position - Invacare Top End Crossfire T6 Owner's Operator And Maintenance Manual

SECTION 9—WHEEL LOCKS
Push-to-Lock or Pull-to-Lock Wheel Locks
Mounting Screws
Wheel
Lock
FIGURE 9.1 Replacing/Adjusting the Wheel Locks

Changing Wheel Lock Handle Position

NOTE: For this procedure, refer to FIGURE 9.2.
1. Loosen, but DO NOT remove, the rear handle mounting screw.
2. Remove the front handle mounting
screw and locknut.
3. Align the front handle mounting hole
with one of three desired mounting
positions on the wheel lock.
4. Using the front handle mounting screw
and locknut, secure the handle to the
wheel lock.
5. Securely tighten the front and rear
handle mounting screws and locknuts.
6. Repeat STEPS 1-5 on remaining wheel
lock handle.
™
Crossfire Series Wheelchairs
3/16 inch
(1/8-inch)
Wheel
Tire
Lock Shoe
FIGURE 9.2 Changing Wheel Lock Handle
58
Under Mount Wheel Lock
Mounting Screws
Wheel Lock
Wheel lock Handle
Rear Handle
Mounting
Screw
Position
3/16 inch
(1/8-inch)
Wheel
Lock Shoe
Tire
Mounting
Positions
Front Handle
Mounting
Screw and
Locknut
Part No 1134872