Appendix B Port Descriptions And Led Status; Module Port Descriptions - Juniper NetScreen-5000 Series Installation And Configuration Manual

Appendix B
Port Descriptions and LED Status

Module Port Descriptions

Table 15: NetScreen-5000 Series Management Module Ports
Port Description
Console Enables a serial connection, to establish terminal sessions with the system. Used for
launching CLI sessions.
Modem Enables a serial modem connection for establishing dial-up sessions.
MGT Enables a connection for establishing out-of-band management sessions from outside
of the network.
HA1 Enables connection with another device in a redundancy cluster, where one device
serves as the master (primary) device, and the other serves as the backup (secondary)
device.
HA2 Enables connection with another device in a redundancy cluster, where one device
serves as the master (primary) device, and the other serves as the backup (secondary)
device.
This appendix provides detail on port descriptions and LED status for the
NetScreen-5000 Series modules.
"Module Port Descriptions" on page 61
"Module LED Descriptions" on page 62
"Status LED States" on page 62
"Power Supply LEDs" on page 64
"Fan LED" on page 65
Table 15 details the ports on the 5000-M, 5000-M2, and 5000-MGT3 management
modules.
Type Speed/Protocol
RJ-45 9600 Bps/
RS-232
RJ-45 9600 Bps/
RS-232
RJ-45 10/100 Mbps/
Ethernet
SFP 1 Gbps/
Gigabit Ethernet
SFP 1 Gbps/
Gigabit Ethernet
Module Port Descriptions
61