Juniper NetScreen-5000 Series Installation And Configuration Manual page 46

NetScreen-5000 Series Hardware Installation and Configuration Guide
46
Removing and Reseating Modules
Figure 18: Removing a NetScreen-5200 Module (NetScreen-5400 Similar)
Loosen screws
3. Gently slide the module card out of the chassis.
To install a module in a NetScreen-5000 Series system:
1. Be sure the module is right-side-up and the ejector/injector levers are extended.
2. Slide the module into the appropriate slot of the chassis, until it is seated in the
backplane.
3. To secure the module in the chassis, close the ejector/injector levers by pushing
on them toward the center of the module.
Swing levers outward