Connecting And Disconnecting Gigabit Ethernet Cables - Juniper NetScreen-5000 Series Installation And Configuration Manual

Hide thumbs Also See for NetScreen-5000 Series:

Table of Contents

NetScreen-5000 Series Hardware Installation and Configuration Guide

Connecting and Disconnecting Gigabit Ethernet Cables

Figure 28: Removing the NetScreen-5400 Fan-tray Filter

4. Replace the filter.

5. Align the new fan module in the fan bay, and then push it straight in.

6. Secure the fan module in place by tightening the thumbscrews clockwise.

To connect a Gigabit Ethernet cable to a Small Form factor Pluggable (SFP)

connector transceiver port:

1. Hold the cable clip firmly but gently between your thumb and forefinger, with

your thumb on top of the clip and your finger under the clip. (Do not depress

the clip ejector on top of the clip.)

2. Slide the clip into the transceiver port until it clicks into place. Because the fit is

close, you may have to apply some force to seat the clip. Apply force evenly and

gently to avoid clip breakage.

To remove the cable from the transceiver port:

1. Make sure the black transceiver ejector under the port is not pressed in;

otherwise, when you attempt to remove the cable, the transceiver might come

out with the cable still attached.

2. Hold the cable clip firmly but gently between your thumb and forefinger, with

your thumb on top of the clip and your finger under the clip.

3. Use your thumb to gently press the clip ejector on top of the clip, first down and

then forward. This action loosens the clip from the transceiver port.

4. Pull the clip from the transceiver port.

Table of Contents