Removing And Installing Sfp And Xfp Transceivers - Juniper NetScreen-5000 Series Installation And Configuration Manual

Removing and Installing SFP and XFP Transceivers

To remove an SFP or XFP transceiver from a module:
1. Push in the black ejector (located on the underside of the transceiver) until it
2. Grasp the transceiver at both sides, and then pull the transceiver toward you to
To install an SFP or XFP transceiver into a module:
1. Grasp the transceiver with the label facing up, and then insert it into the
2. Check to see if the black transceiver ejector extends fully out to the front of the
locks into place, disengaging the transceiver.
remove it from the module.
transceiver slot until seated.
ejector slot, flush with the port portion of the transceiver.

Removing and Installing SFP and XFP Transceivers

Servicing the Device
55