Installing And Connecting An Ac Power Supply - Juniper NetScreen-5000 Series Installation And Configuration Manual

Hide thumbs Also See for NetScreen-5000 Series:

Table of Contents

2. Use the screws to attach the left and right brackets to the rack.

Figure 14: Rack Mounting the NetScreen-5400

Installing and Connecting an AC Power Supply

To install and connect an AC power supply to the NetScreen-5000 Series device:

1. On the NetScreen-5200, slide the power supply into one of the power

2. Fasten the power supply to the system by tightening the corner screws into the

3. If you want to install two power supplies in the NetScreen-5200 or three power

4. Connect the female end of a standard power cord to the male connector on the

5. Connect each power cord to a standard 100-240-Volt power outlet.

compartments in the back of the system.

On the NetScreen-5400, slide the power supply into one of the power

compartments on the front of the system.

eyelets on the sides of the power supply.

supplies in the NetScreen-5400, then repeat steps 1 and 2 for the remaining

power supplies.

back of each power supply.

Installing the Device

Table of Contents