Juniper NetScreen-5000 Series Installation And Configuration Manual page 43

3. Press y.
The following message appears:
!! Reconfirm Lost Password Reset !! If you continue, the entire configuration of the
device will be erased. In addition, a permanent counter will be incremented to
signify that this device has been reset. This is your last chance to cancel this
command. If you proceed, the device will return to factory default configuration,
which is: System IP: 192.168.1.1; username: netscreen; password: netscreen.
Would you like to continue? y/[n]
4. Press y to reset the device.
You can now log in in using netscreen as the default admin name and
password.
Configuring the Device
Using CLI Commands to Reset the Device
43