Module Led Descriptions; Status Led States; Interpreting Status Leds For The Management Modules - Juniper NetScreen-5000 Series Installation And Configuration Manual

NetScreen-5000 Series Hardware Installation and Configuration Guide
Table 16: NetScreen-5000 Series Secure Port Module Ports
SPM Type Port
5000-8G Network Ports 1-8
5000-8G2 Network ports 1
through 8
5000-8G2-G4 Network ports 1
through 8
5000-2G24FE Network ports 1 and
2
Network ports 3
through 26
5000-2XGE Network ports 1 and
2
5000-2XGE-G4 Network ports 1 and
2

Module LED Descriptions

Status LED States

Interpreting Status LEDs for the Management Modules

Table 17: Management Module Status LEDs (Page 1 of 2)
LED Color
CPU Green
Utilization
Off
62
Module LED Descriptions
Table 16 details the ports on the 5000-8G, 5000-8G2 and 5000-8G2-G4 Secure Port
Modules (SPMs).
Description
Eight 1 Gigabit ports with an aggregate
throughput of 4Gbps.
Eight 2-Gigabit ports with an aggregate
throughput of 8 Gbps.
Eight 2-Gigabit ports with an aggregate
throughput of 8 Gbps.
Two high-speed network ports for general
connection to the network.
Twenty-four network ports for general
connection to the network.
Two 10-Gigabit Ethernet XFPs with a
throughput of 10 Gbps.
Two 10-Gigabit Ethernet XFPs with a
throughput of 10 Gbps.
This section provides descriptions of the LEDs on NetScreen-5000 Series modules.
Two types of LEDs exist on the modules:
Status LEDs. These LEDs reflect certain conditions that exist on the system at
large and do not explicitly refer to a given port.
Port LEDs. These LEDs reflect basic conditions (for example, a link connection
status) that exist for a specific port.
This section describes Status LED states on all modules.
The Status LEDs indicate whether the management module is operating properly.
Table 17 describes the status possibilities for each.
Meaning
Consists of an array of five LEDs that indicate the current level of CPU utilization. Utilization is
defined as the amount of traffic detected on the device at any given time. The CPU utilization
LEDs represent the following percentages of possible utilization: 5%, 10%, 25%, 50%, and
90%.
When all are off, indicates less than 5 percent CPU use.
Type Speed/Protocol
SFP 1 Gbps/Gigabit Ethernet
SFP 2 Gbps/Gigabit Ethernet
SFP 2 Gbps/Gigabit Ethernet
SFP 1 Gbps/Gigabit Ethernet
RJ-45 10/100 Mbps/Ethernet
XFP 10 Gbps/Gigabit Ethernet
XFP 10 Gbps/Gigabit Ethernet