Table of Contents
Advertisement
NOTE:
Use lowercase letters only. The username and password are both case-sensitive.
5. (Optional) By default, the console times out and terminates automatically after
Starting a Console Session Using Dialup
Each NetScreen-5000 Series system provides a modem port that allows you to
establish a remote console session using a dialup connection through a 9600 bps
modem. Dialing into the modem establishes a dialup console connection.
The Terminal type for dialup sessions must be vt100. For example, in Hilgreave
NOTE:
HyperTerminal (a standard terminal application), select the File menu. select
Properties, select the Settings tab, and then under the Emulation dropdown
menu, select VT100.
Establishing a GUI Management Session
To access a NetScreen-5000 Series system with the WebUI management
application:
1. Connect your computer (or your LAN hub) to the MGT interface using a
2. Launch your browser, enter the IP address of the MGT interface in the URL field,
10 minutes of idle time. To change this timeout interval, use the following
command:
set console timeout number
where number is the length of idle time in minutes before session termination.
To prevent any automatic termination, specify a value of 0.
Category-5 Ethernet cable. (The MGT interface is on the management module,
which alway resides in slot 1.)
and then press Enter.
For example, if you assigned the MGT interface an IP address of
10.100.2.183
/16, then enter:
http://10.100.2.183
The ScreenOS WebUI software displays the login prompt.
Configuring the Device for Telnet and WebUI Sessions
Configuring the Device
39
Advertisement
Table of Contents
