Configuring The Chassis Alarm; Configuring Jumbo Frames - Juniper NetScreen-5000 Series Installation And Configuration Manual

NetScreen-5000 Series Hardware Installation and Configuration Guide

Configuring the Chassis Alarm

Configuring Jumbo Frames

40
Configuring the Chassis Alarm
3. Enter netscreen in both the Admin Name and Password fields, then click Login.
(Use lowercase letters only. The Admin Name and Password fields are both
case-sensitive.)
The ScreenOS WebUI application window appears.
The NetScreen-5000 Series system allows you to configure the chassis alarm, an
audible warning that sounds when a system failure or hazardous event occurs. To
determine which failures and events trigger the chassis alarm:
1. Configure the audible alarms with the following command:
set chassis audible-alarm string
where string can be any of the following keywords:
all Enables all chassis alarms.
battery Sets the chassis alarm to sound when a battery fails.
fan-failed Sets the chassis alarm to sound when a fan fails.
power-failed Sets the chassis alarm to sound when a power supply fails.
temperature Sets the chassis alarm to sound when the temperature goes outside of the
acceptable range.
2. After configuring the alarm, it is advisable to view alarm environment
information with the following command:
get chassis
The 5000-8G2 and 5000-2XGE SPMs support jumbo frames that are up to 9,830
bytes. To set jumbo frames, use the set environment max-frame-size=9830 CLI
command. You must reboot the system before this feature can take effect.