Chapter 2 Chapter 3 Configuring The Device - Juniper NETSCREEN-5GT User Manual

Chapter 2
Chapter 3
Configuring the Device
This chapter describes how to configure a NetScreen-5GT after you have installed and
connected it to your network and to a power source. After completing the necessary
configurations, users in your network will be able to access the Internet through the
NetScreen-5GT while resources in your network are protected from outside computers.
Note: You must register your product at
NetScreen ScreenOS services, such as internal antivirus or Deep Inspection Signature
Service, can be activated on the device. After registering your product, use the WebUI or
CLI to obtain the subscription for the service. For more information about registering your
product and obtaining subscriptions for specific services, see the "System Parameters"
chapter in Volume 2 of the NetScreen Concepts & Examples ScreenOS Reference Guide.
Note: If you access the device for the first time using the NetScreen ScreenOS WebUI
graphical interface, the Initial Configuration Wizard appears when you log in to the
WebUI. This Wizard guides you through the configuration described in this chapter. For
more information about starting the Initial Configuration Wizard, refer to the Juniper
Networks NetScreen-5GT Getting Started Guide.
NetScreen-5GT
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
so that certain
www.juniper.net/support/
2
3