Single Integrated Vent Duct Removal; Internal Duct And Elbow Removal - Fisher & Paykel DishDrawer DD247 Service Manual

71

9.29 Internal Duct and Elbow Removal

(some integrated models only)
Remove the tub to gain access to the duct, refer
1.
section 9.6.
To remove the chassis duct tube, remove the 13mm
2.
nut to release the elbow and gently pull the tube from
the elbow duct.
To remove the rear duct elbow, the product will need
3.
to be uninstalled and pulled forward from the joinery
to gain access to the elbow. To release elbow from the
chassis, squeeze the side tabs and pull outwards.
NOTE: When pulling the product forward out of the
joinery, remember to feed the service and ducting pipes
through the service holes to stop them from getting
damaged.
The ducting insulated hose is attached to the rear
4.
elbow and ducted through the joinery.
NOTE: Refer to the product installation guide for more
detailed installation information.
Elbow
Side Tab
Side Tabs
Insulated Vent Hose
D
D
13mm Nut