Table of Contents
Advertisement
22
3.11 Filter Plate
The filter plate is a stainless steel disk positioned below the dish rack and spray arm and completely
encompasses the base of the tub.
The drain filter has a rubber over mould around the edge to reduce soil re-depositing. Between the filter plate
and rotor an o ring is also fitted to ensure a tight fit to reduce water leaks. These improvements will ensure a
better wash performance.
The drain filter fits tightly into the filter plate, due to the rubber over mould around the edge.
3.11.1 The Filter System
The tub has vanes that swirl the water around and over the filter plate. At the front of the tub, located as part of
the filter plate, is the drain filter.
The drain filter is secured into the filter plate over mould which helps sealing.
Large soils collect in the drain filter and only smaller soil flows through its micro-mesh filter, eliminating re-
depositing of soil during the wash.
The drain filter should be regularly checked and cleaned.
3.11.2 Removing and Cleaning the Drain Filter and Filter Plate
The drain filter can be emptied with the dish rack in place by removing the cutlery basket and opening the
plastic section of the dish rack.
To remove the drain filter pull upwards to release, clean under running water, when refitting ensure the drain
filter sits flush with the filter plate.
The filter plate is removable for cleaning by removing the dish rack and spray arm and unlocking the locknut by
turning it anti-clockwise. Turning it too far will also release the rotor and may allow it to be lifted out with the
filter plate.
Clean under running water. When refitting ensure the 3 inner locking pins on the lock ring are securely fitted.
3.12.2 Removing and Cleaning the Drain Filter and Filter Pla
Hide quick links:
Advertisement
Table of Contents
