Drying Duct - Top Tub Only; Drying Fan And Flap Valve - Fisher & Paykel DishDrawer DD247 Service Manual

60

9.7 Drying Duct - Top Tub Only

Open the drawer and remove the drawer front
1.
(refer section 9.2).
Use long nose pliers to gently release the plastic clips
2.
while pulling the duct downwards.
Refit in reverse manner, and ensure clips locate
3.
correctly.

9.8 Drying Fan and Flap Valve

Remove the drawer front (refer section 9.2).
1.
With a small bladed screwdriver, carefully release the
2.
small plastic clips holding the rinse aid indication LED
in place in the detergent dispenser and remove the
LED.
Release the rubber tabs securing the fan.
3.
Disconnect the wire harness from the electronic
4.
controller.
The drying fan will now come free.
5.
Refit in reverse manner.
6.
7.
Note: The fan housing flapper can be replaced by
removing the cover and lifting the flapper out the
housing.
To remove the cover, use a small screwdriver to depress
the 2 clips at the rear, and slide it forward to release.
Clips
Clips
Rubber tab
Clips
Flapper
Slide