Table of Contents
Advertisement
47
For Integrated or Flat Door Models:
Check the stator windings to ensure correct
1.
resistances, this can be done on harness P201 at the
controller, check between pin 1 &2, 2 & 3, 1 & 3 the
reading should be 8.0 ohms per winding, 16 ohms
phase to phase. (refer section 9 for more detail.)
Check the hall sensor (RPS) is correctly located and
2.
is held firmly in place on the motor stator and that
the wiring harness is connected to it.
Replace the motor rotor, place the product in "HO"
3.
mode (refer pages 30 & 31), run the fill water valve
(FU) and fill the tub with approx 2.5L (0.7 gal) of
water, once at the correct level switch off the valve
in HO mode.
Run the motor in drain direction (P2) for 10 seconds,
4.
if a long low tone is played each second, then the
motor stator is likely to be faulty and should be
replaced (refer section 9.18).
Fault code E2 - Sub Code 03 - Motor Not Drawing Enough Current
Check the harness connections at the motor and
1.
controller for signs of any water damage, corrosion
or arcing. Replace if damaged.
Check the hall sensor (RPS) is correctly located and is
2.
held firmly in place on the motor stator and that the
wiring harness is connected to it.
Check the stator windings to ensure correct resist-
3.
ances, this can be done on harness P201 at the
controller, check between pin 1 &2, 2 & 3, 1 & 3 the
reading should be 8.0 ohms per winding, 16 ohms
phase to phase. (refer section 9 for more detail.)
Check the motor rotor is correctly fitted to the motor
4.
housing.
Replace the motor rotor, place the product in "HO"
5.
mode (refer pages 30 & 31), run the wash motor (P1)
for at least 10 seconds. If a long low tone is played
each second, then the current draw is outside of the
allowable limit. In this case replace the controller
NOTE: When running the wash motor in P1 direction,
the tub must be closed to ensure the prism circuit is
closed.
Controller Harness P201
11
Corrosion Damage Example
Hide quick links:
Advertisement
Table of Contents
