Lid - Fisher & Paykel DishDrawer DD247 Service Manual

Dishdrawer
Table of Contents

Advertisement

66

9.19 Lid

Remove the tub as per section 9.6.
1.
On the right hand side of the lid, insert a flat blade
2.
screwdriver into the yoke slots between the lid flange
and the yoke.
Twist the screwdriver while pulling down on the lid to
3.
disengage the clip. Repeat for each clip on both yokes.
NOTE: Do not pull down on the lid seal.
Pull the lid down 10mm (3/8") on one side. Pull the
4.
opposite side of the lid down until it is clear of the
yoke. The high side of the lid can then be pulled to
the bottom of the yoke slots. The lid is now free to
be removed from the chassis on an angle as shown.
NOTE: For more detail on lid removal, click on the link
in the following page to watch the short video clip on
lid removal.
To reassemble the lid, angle the lid into the chassis,
5.
ensure the lid is the correct way round, the words "
FRONT" are printed on the top of the lid and should be
at the front of the product.
Engage the T-Rib on the high side of the lid into the
6.
bottom of the yoke slots. Swing the opposite side of
the lid past the yoke until it sits into the bottom of the
yoke slots.
NOTE: The T-Ribs make the lid wider, so some force is
required to push past the yoke.
Clip the lid into place. Start by pushing one corner of
7.
the lid up until it clicks. Next clip the diagonal corner
up. The lid is now assembled and should look like the
image.
D
Yoke Slots
Correctly Fitted
Incorrectly Fitted
D

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dishdrawer dd607

Table of Contents