Lid Actuator - Fisher & Paykel DishDrawer DD247 Service Manual

68
9.22 Slide Rail Replacement.
Remove the tub, refer section 9.6
1.
Remove the required lid actuator from the slide rail being
2.
replaced, refer section 9.21.
Remove the appropriate chassis trim (refer section 9.27) to
3.
gain access to the screws of the rail being replaced.
Remove the 2 hex drive screws securing the rail to the chassis.
4.
Tap the slide rails from underneath at the front to free from
5.
it's location in the chassis.
Pull forward to release the rear locating tabs.
6.
Refit in reverse order, take care that the chassis is square
7.
before tightening the screws.
9.23 Mains Filter Cover and PCB Mains Filter
Remove the lower tub, refer section 9.6
1.
Release the clips on the mains filter cover and lift it off.
2.
Disconnect all wiring to the PCB mains filter.
3.
Remove the earth screw through the wire and the
4.
mains filter housing to the chassis.
Use a screwdriver to release the clips holding the
5.
circuit board inside the housing and lift it out.
Refit in reverse manner.
6.
Hex Drive Screws
Rail Rear Locating Tabs
Inlet Hose
Water Valve
D
D
D
Clips
Flood Sensor
MFB