Fisher & Paykel DishDrawer DD247 Service Manual page 10

10
Component Specifications
Component
Controller
Water Inlet Valve
Dispenser Coils
Rinse Aid Tank
PCB Mains Filter
(2 Types - Single / Double)
Motor
Drain Speed
Wash Speed
Stator
Heater plate 230V
Wattage
Water Heater Track
Power Supply Resistor
Temperature Sensor
Heater Plate 110V
Wattage
Water Heater Track
Power Supply Resistor
Temperature Sensor
Fusible link
Water Inlet hose
Water Pressure
Drain Hose
Power Cord
NZ, AU, GB, EU, DK
US, CA, TW
all markets
all markets
all markets
NZ, AU, GB, EU, DK
US, CA, TW
Pump out rate 5 litres / min.
NZ, AU, GB, EU, DK
Located on the heater plate
US, CA, TW
Located on the heater plate
Located on the heater plate
Pressure Rating
Length from chassis edge
(viewed from the front)
Non water softener models
Water softener models
NZ, AU, GB, EU, DK
length from chassis exit when
product viewed from the front
US, CA, TW
Specification
230V
120V
24V DC
65+/- 10 Ohms per coil
2.5litres/min (0.65 US gal/min)
24V DC per coil
65+/- 10 Ohms per coil
50mls (approx. 25 washes)
3.05 cubic inches
230V AC
110V AC
80V DC 3 Phase Brushless
5000 RPM
2200 - 2800 RPM
8.0 Ohms (per winding), 16 ohms phase to
phase from the controller connector
230V AC
1045W
50 Ohms +/- 4 Ohms
98 Ohms +/- 7 Ohms
12000 Ohms @ 20
C
o
8300 Ohms @ 30
C
o
3000 Ohms @ 60
C
o
120V AC
650W
24 Ohms +/- 3 Ohms
24 Ohms +/- 3 Ohms
12000 Ohms @ 68
F
o
8300 Ohms @ 86
F
o
3000 Ohms @ 140
F
o
268 – 302 (514 – 576
C
o
1MPa (145psi)
1650mm (64 ¾" ) left hand side
1250mm (49") Right hand side
1MPa (145 psi) max,
0.03 MPa (4.3psi) min
1MPa (145psi) max,
0.1MPa (14.5psi) min
2000 mm (78 ½" )from left hand side
1800mm (70 ½") from right hand side.
1650mm
29 ½" LH side, 27 ½" RH side
)
F
o