Table of Contents
Advertisement
6.0
SERVICE PROCEDURES
6.1.
Drawer Front Removal
6.1.1
Slide open drawer.
6.1.2
Locate draw pin on either side of the tub.
6.1.3
Using a sharp pair of long nose pliers or slip jaw pliers grasp the center dividing
web of the pin and pull away from the tub to remove the pin.
Support the drawer front with your hand while doing this.
Note: The pin web is vertical.
6.1.4
With both pins removed the bottom of the drawer front can now be eased down
and forward so as to clear the microswitch lever.
6.1.5
Now carefully pull the drawer front down to allow it to come free from the top
locating slots.
6.1.6
This allows the drawer front to come away with the handle insert and insulation.
6.1.7
Refit in reverse manner insuring the drawer slides are right forward and the pin
secures through the hook on the front end of the slide.
Note: When reinserting the pins make sure the dividing web is vertical.
6.2.
Handle and LCD Display Removal
6.2.1
Remove the drawer front as per instructions in 6.1.
6.2.2
The handle clips under two location inserts either side of the tub. Pull forward on
the handle tabs and this will release them from the location inserts.
6.2.3
Disconnect the seven wire harness from the electronic controller to the LCD or
Badge.
6.2.4
The handle may now be lifted clear.
The LCD display is held in place by a spring tab on one end. Using a small blade
screwdriver slip it down the end of the LCD with the single tab. This will release
the LCD.
6.2.6
The wiring harness can now be unplugged from the LCD.
6.2.7
Push pads can now be removed. The LCD display holds these in place.
6.2.8
Refit in reverse manner.
- 38 -
Advertisement
Table of Contents
