Lid Actuator; Slide Rail Replacement - Fisher & Paykel DishDrawer DD605 Service Manual

8.18 Lid Actuator

8.18.1 Remove the tub (refer Section 8.5).
8.18.2 Remove the lid actuator harness plug by releasing the clip on the lid actuator.
8.18.3 Release the lid actuator from the bottom of the yoke by pressing with your
thumb against one of the locking tabs.
8.18.4 For a right-hand lid actuator, carefully release the clip at the rear of the lid
actuator and slide the lid actuator towards the rear of the chassis to release it
from the slide rail.
8.18.5 For a left-hand lid actuator, the clip is in front of the lid actuator, and once
released, the lid actuator will slide towards the front of the chassis to release it
from the slide rail.
8.18.6 The lid actuator can now be removed by dropping it down through the slot in the
slide mounting bracket.
8.18.7 When reconnecting the lid actuator to a yoke, ensure the lid and yoke
assemblies are in the fully raised position. To line up the lid actuator connecting
arm with the yoke, it may need to be wound up or down manually.
Note: It is important that all the clips on the lid actuator case are done up and that
none are broken.

8.19 Slide Rail Replacement

8.19.1 Remove the tub (refer Section 8.5).
8.19.2 Remove the lid actuator from the slide rail (refer Section 8.18).
8.19.3 Bottom slide rails only. Remove the lower chassis trim (refer Section 8.24) to
gain access to the screws. Remove the two hex drive screws securing the slide
mounting bracket at the front.
8.19.4 Tap the slide rails from underneath at the front. This will knock the slide rail up
and free from its location in the chassis.
8.19.5 The slide runner may now be pulled forward to release it from its location in the
rear of the chassis.
8.19.6 Refit in reverse manner.
8.19.7 Take care to ensure the chassis is square before tightening these screws.
53
599447A