Yoke; Lid Actuator - Fisher & Paykel DishDrawer DD24D Series Service Manual

8.20

Yoke

1. Remove the lid (refer to Section 8.6).
2. Release the lid actuator from the bottom of the yoke by pushing
with your thumb against one of the locking tabs. Note: Tall Tub
models use an adaptor between the yoke and lid actuator.
3. Slide the front of the yoke downward at an angle until it moves
out of the track in the rear of the trim, and is clear of the chassis
flange as shown.
Refit in the reverse manner taking care that the yoke is the correct
way around.
Note:
• There are both left hand and right hand yokes.
• Do not bend the yoke when refitting it.
• Locate the rear end below the chassis tab at the rear of the
chassis first, then slide the front up in behind the trim to ensure
the front yoke peg locates correctly in the track behind it.
8.21

Lid Actuator

1. Remove the tub (refer to Section 8.6).
2. Remove the lid actuator harness plug by releasing the clip on
the lid actuator.
3. Release the lid actuator from the bottom of the yoke by
pressing with your thumb against one of the locking tabs.
4. For a right-hand lid actuator, carefully release the clip at the
rear of the lid actuator and slide the lid actuator towards the
rear of the chassis to release it from the slide rail.
5. For a left-hand lid actuator, the clip is in front of the lid
actuator, and once released, the lid actuator will slide towards
the front of the chassis to release it from the slide rail.
6. The lid actuator can now be removed by dropping it down
through the slot in the slide mounting bracket.
Refit in reverse manner.
When reconnecting the lid actuator to a yoke, ensure the lid and
yoke assemblies are in the fully raised position. To line up the lid
actuator connecting arm with the yoke, it may need to be wound up
or down manually.
It is important that all the clips on the lid actuator case are
Note:
done up and that none are broken.
55
599735A