ZyXEL Communications P-792H User Manual page 64

Chapter 6 WAN Setup
Table 12 Network > WAN > Internet Access Setup (continued)
LABEL
Tag VLAN ID for
egree packets
Enter 802.1P
Priority
Enter 802.1Q
VLAN ID
Line
IP Address
Subnet Mask
Gateway IP
address
DNS Server
First DNS Server
Second DNS
Server
Third DNS Server
Connection (PPPoA and PPPoE encapsulation only)
Nailed-Up
Connection
64
DESCRIPTION
Select this option to add the VLAN tag (specified below) to the
outgoing traffic through this connection.
This is available only when you select PTM in the Transfer Mode
field.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag
into a MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic
through this connection. The greater the number, the higher the
priority level.
Type the VLAN ID number (from 1 to 4094) for traffic through this
connection.
Select the DSL line you want the P-792H v2 to use as a default for
outgoing traffic (remote node 1).
This option is available if you select Routing in the Mode field.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP
address is not fixed; the ISP assigns you a different one each time you
connect to the Internet.
Select Obtain an IP Address Automatically if you have a dynamic
IP address; otherwise select Static IP Address and type your ISP
assigned IP address in the IP Address field below.
This option is available if you select ENET ENCAP in the
Encapsulation field.
Enter a subnet mask in dotted decimal notation.
This option is available if you select ENET ENCAP in the
Encapsulation field.
Specify a gateway IP address (supplied by your ISP).
Select Obtained From ISP if your ISP dynamically assigns DNS
server information (and the P-792H v2's WAN IP address) and you
select Obtain an IP Address Automatically.
Select User-Defined if you have the IP address of a DNS server.
Enter the DNS server's IP address in the field to the right. If you chose
User-Defined, but leave the IP address set to 0.0.0.0, User-
Defined changes to None after you click Apply. If you set a second
choice to User-Defined, and enter the same IP address, the second
User-Defined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. You must
have another DNS server on your LAN, or else the computers must
have their DNS server addresses manually configured. If you do not
configure a DNS server, you must know the IP address of a computer
in order to access it.
Select Nailed-Up Connection when you want your connection up all
the time. The P-792H v2 will try to bring up the connection
automatically if it is disconnected.
P-792H v2 User's Guide