The Reset Button; Using The Reset Button - ZyXEL Communications P-792H User Manual

Chapter 1 Getting To Know Your P-792H v2
The following table describes the LEDs.
Table 1 LEDs
LED
POWER
LAN 1~4
DSL
INTERNET

1.5 The RESET Button

If you forget your password or cannot access the web configurator, you will need
to use the RESET button at the back of the device to reload the factory-default
configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to "1234".

1.5.1 Using the RESET Button

Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for
2
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.
28
COLOR STATUS DESCRIPTION
Green On The P-792H v2 is receiving power and functioning
properly.
Blinking The P-792H v2 is rebooting or performing
diagnostics.
Red On Power to the P-792H v2 is too low.
Off The system is not ready or has malfunctioned.
Green On This port has a successful Ethernet connection.
Blinking This port is sending/receiving data.
Off This port is not connected.
Green On The DSL line is up.
Blinking The P-792H v2 is initializing the DSL line.
Off The DSL line is down.
Green On The Internet connection is up, and the P-792H v2 has
an IP address. (If the P-792H v2 uses RFC 1483 in
bridge mode, this light does not turn on, but it does
blink when the P-792H v2 is sending/receiving data.)
Blinking The P-792H v2 is sending/receiving data.
Red On The P-792H v2 tried to get an IP address, but an
error occurred.
Off The Internet connection is down.
P-792H v2 User's Guide