General Nat Examples - ZyXEL Communications P-792H User Manual

Chapter 30 NAT Setup
Enter 1 to configure the server set used by SUA, or enter the number of the server
3
set you want to modify for full-feature NAT. In Menu 15.2 - NAT Server Setup,
configure the port forwarding rules.
Figure 160 Menu 15.2: NAT Server Setup
The first entry is for the Default Server. The following table describes the labels in
this menu.
Table 125 Menu 15.2: NAT Server Setup
FIELD
Rule
Start Port
End Port
IP Address

30.4 General NAT Examples

The following are some examples of NAT configuration.
328
Menu 15.2 - NAT Server Setup
Rule Start Port No.
---------------------------------------------------
1. Default
2. 80
3. 0
4. 0
5. 0
6. 0
7. 0
8. 0
9. 0
10. 0
11. 0
12. 0
DESCRIPTION
This field is a sequential value, and it is not associated with a specific
rule. The sequence is important, however. The P-792H v2 checks
each active rule in order, and it only follows the first one that applies.
This field displays the beginning of the range of port numbers
forwarded by this rule.
This field displays the end of the range of port numbers forwarded by
this rule. If it is the same as the Start Port, only one port number is
forwarded.
This field displays the IP address of the server to which packet for
the selected port(s) are forwarded.
End Port No. IP Address
Default 0.0.0.0
80 192.168.1.10
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
0 0.0.0.0
P-792H v2 User's Guide