ZyXEL Communications P-792H User Manual page 296

Chapter 25 WAN Setup
Table 110 Menu 2: WAN Setup (continued)
FIELD
Service Type
Rate Adaption This field is configurable if Service Type is Server. Press [SPACE BAR] to
Transfer Max
Rate(Kbps)
Transfer Min
Rate(Kbps)
Standard
Mode
Wan Backup
Setup
Check
Mechanism
Check WAN IP
Address1
Check WAN IP
Address2
Check WAN IP
Address3
KeepAlive Fail
Tolerance
Recovery
Interval(sec)
296
DESCRIPTION
Press [SPACE BAR] to indicate whether the P-792H v2 is the server or the
client in the DSL connection. Select Server if this P-792H v2 is the server
in a point-to-point application. (See
select Client.
let the P-792H v2 adjust the speed of its connection to that of the other
device.
This field is enabled if Service Type is Server. Press [SPACE BAR] to set
the maximum rate at which the P-792H v2 sends and receives
information. If you enable Rate Adaption, the P-792H v2 adjusts to the
speed of the other device and may exceed this rate.
The rate range is from 192~5696 Kbps.
This field is enabled if Service Type is Server. Press [SPACE BAR] to set
the minimum rate at which the P-792H v2 sends and receives
information. If you enable Rate Adaption, the P-792H v2 adjusts to the
speed of the other device and may transfer information at less than this
rate.
The rate range is from 192~5696 Kbps.
This field is enabled if Service Type is Server. Press [SPACE BAR] to
select the G.SHDSL compliant specification that P-792H v2 uses in the
DSL connection: ANSI(ANNEX_A) or ETSI(ANNEX_B).
Select the method that the P-792H v2 uses to check the DSL connection.
Select DSL Link to have the P-792H v2 check if the connection to the
DSLAM is up. Select ICMP to have the P-792H v2 periodically ping the IP
addresses configured in the Check WAN IP Address fields.
Configure this field to test your P-792H v2's WAN accessibility. Type the IP
address of up to three reliable, nearby computers (for example, your
ISP's DNS server address).
Note: If you activate either traffic redirect or dial backup, you must
configure at least one IP address here.
When using a WAN backup connection, the P-792H v2 periodically pings
the addresses configured here and uses the other WAN backup
connection (if configured) if there is no response.
Type the number of times (2 recommended) that your P-792H v2 may
ping the IP addresses configured in the Check WAN IP Address field
without getting a response before switching to a WAN backup connection
(or a different WAN backup connection).
When the P-792H v2 is using a lower priority connection (usually a WAN
backup connection), it periodically checks to whether or not it can use a
higher priority connection.
Type the number of seconds (30 recommended) for the P-792H v2 to wait
between checks. Allow more time if your destination IP address handles
lots of traffic.
Chapter 5 on page 67.) Otherwise,
P-792H v2 User's Guide