Restore Using Ftp - ZyXEL Communications P-792H User Manual

Chapter 35 Firmware and Configuration File Maintenance
Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE YOUR P-792H v2. When the Restore
Configuration process is complete, the P-792H v2 will
automatically restart.

35.4.1 Restore Using FTP

For details about backup using (T)FTP please refer to earlier sections on FTP and
TFTP file upload in this chapter.
Figure 204 Menu 24.6: Restore Configuration
To transfer the firmware and the configuration file, follow the procedure
below:
1. Launch the FTP client on your computer.
2. Type "open" and the IP address of your system.
SMT password as requested.
3. Type "put backupfilename rom-0" where backupfilename is the name of
your backup configuration file on your computer and rom-0 is the
remote file name on the system. This restores the configuration to
your system.
4. The system reboots automatically after a successful file transfer.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on restoring using TFTP (note that you must
remain on this menu to restore using TFTP), please see your user manual.
Launch the FTP client on your computer.
1
Enter "open", followed by a space and the IP address of your P-792H v2.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "1234").
4
Enter "bin" to set transfer mode to binary.
5
Find the "rom" file (on your computer) that you want to restore to your P-792H
6
v2.
Use "put" to transfer files from the P-792H v2 to the computer, for example, "put
7
config.rom rom-0" transfers the configuration file "config.rom" on your computer
to the P-792H v2. See earlier in this chapter for more information on filename
conventions.
376
Menu 24.6 - Restore Configuration
Then type "root" and
P-792H v2 User's Guide