User Mode 5 - U5 (Automatic Initial Media Cut) - Xerox Wide Format 6622 User Manual

User Modes
3. Press Enter again to gain access to the time interval.
4. To change the time, press <-- Key to increase and --> Key to decrease, then press Enter
to save the data.
The display value is in minutes, and the selectable ranges are 10, 15, 20, 30, 40, 50,
60, 90, 120, 180 and 240.
5. After you enter the desired time interval, press the Online Key to exit the User Mode.
NOTE
After 90 minutes of no use, the printer will reset the developer motor and enter
an idle state. A loud "thump" noise will be heard as the motor resets. This is
normal.
User Mode 5 - U5 (Automatic Initial
Media Cut)
You can enable an Initial Media Cut when the printer power is turned on or after Sleep
Mode. If this feature is enabled, the printer will feed and cut 240 mm/9.5 inches of all
4 roll media when the machine is powering up.
1. Press the Menu Key 5 times when the printer is in the Standby mode.
The Menu Key lights green and the Status Display indicates "U5" flashing in the left
side of the display. The current setting is displayed on the right side.
2. Press Enter.
3. To change the value, press --> Key to increase then press Enter to save the data.
Selectable values are 0 and 1.
• 0 is No initial cut at Power On which is the factory default.
• 1 is an initial cut will be made when the printer is turned On.
4. Press the Online Key to exit the User Mode.
7-6 ®
Xerox Wide Format 6622 Solution
User Guide