Misfeed In The Fuser Assembly (J-14) - Xerox Wide Format 6622 User Manual

Problem Solving
9. Return the green Inner Transport Handle to the lock position ensuring it latches.
NOTE
If the Inner Transport Assembly is not locked firmly, the PF Indicator Light on
the Operator Panel will light along with a U-04 Open Error Code on the Status
Display.
10. Close both the Left and Right Side Doors.
11. Open the media drawer selected and rewind the media roll to the original position
which is slightly between the feed rolls. If too much media had advanced, it may
misfeed.
12. Close the Media Drawers.
13. If the leading edge is not sufficiently square, perform the automatic Initial Cut by
pressing the [Select] key to select the appropriate drawer, and then pressing [Cut]
key. Approximately 9.5" (240mm) media will be cut and fed from the printer.

Misfeed in the Fuser Assembly (J-14)

This error may have been caused if the Stacker was not powered on. Clear the misfeed
and ensure the Stacker power is on.
1. Open the Exit Cover.
2. Open both the Left and Right Side Doors.
9-22 ®
Xerox Wide Format 6622 Solution
User Guide