Table of Contents
Advertisement
3. Open both the Left and Right Side Doors.
4. Turn the green Cutter Knob clockwise once and only one revolution to cut the roll
media.
NOTE
Do not rotate the Cutter Knob more than once. If it is rotated several times,
paper fragments may be left in the Cutter area and cause problems.
5. Return the Cutter to the home position by rotating the green Cutter Knob until green
is seen inside of the notch. Green indicates the home position.
CAUTION
Do not rotate the Cutter Knob counter-clockwise. It will damage the Cutter Blade.
6. Close the Side Doors.
7. Remove the cut media from the front inside of the machine.
8. Push in the Manual Feed-in Shelf (Bypass).
9. Rewind the media rolls from both Media Drawer 1 and 2 to be in the original position
which is slightly between the feed rolls. If too much media is advanced, it may misfeed.
10. Close the Media Drawers.
11. If the leading edge is not sufficiently square, perform the automatic Initial Cut by
pressing the [Select] key to select the appropriate drawer, and then pressing [Cut]
key. Approximately 9.5" (240mm) media will be cut and fed from the printer.
®
Xerox
Wide Format 6622 Solution
User Guide
Problem Solving
9-19
Advertisement
Table of Contents
