Dropping The Feed Dog; Changing The Presser Foot; Oto Release; Oto Snap On - Janome 385.8080200 Owner's Manual

Dropping the Feed Dog
The feed dog can be lowered by the drop feed lever
for sewing on buttons, manual embroidery etc.
Push the drop feed lever to the right to lower the feed
dog.
Push the lever to the left to raise the feed dog, it will
return to the up position when starting the machine.
NOTE:
The feed dog should be in up position for normal
sewing. Turn the handwheel toward you to check if
the feed dog comes up after setting the lever in the
up position.
0 Down position
(_ Up position
(_) Feed dog
(_ Handwheel
Changing the Presser Foot
WARNING:
Turn OFF the power'switch before changing the foot
Always use the proper foot for the selected pattern.
Wrong foot can cause needle to break.
To release:
Raise the needle and presser foot.
Press the red button on the back of the foot holder
and the foot will drop off.
O Red button
• To snap on:
Place the presser foot so the pin on the foot lies just
under the groove of the foot holder.
Lower the foot holder tO lock the foot in place.
(&) Groove
_) Pin
Detaching and Attaching the Foot Holder
WARNING:
Turn OFF the power switch before detaching or
attachingthe foot holder.
To detach:
Raise the presser bar and turn the setscrew
counterclockwise to remove it.
Remove the foot holder.
(_ Setscrew
(_D Foot holder
o To attach:
Align the hole in the foot holder with the threaded
hole on the presser bar and insert the setscrew
through the hole. Tighten the setscrew by turning it
clockwise.
• 14