Change Post Parameters - Fujitsu SPARC Enterprise T5440 Service Manual

Parameter
Related Information
"Diagnostic Flowchart" on page 13
■
"Change POST Parameters" on page 31
■
"Run POST in Maximum Mode" on page 32
■
"Detecting Faults Using POST" on page 46
■
"Clear Faults Detected During POST" on page 52
■
SPARC Enterprise T5440 Server Installation and Setup Guide
■
SPARC Enterprise T5440 Server Administration Guide
■

▼ Change POST Parameters

1. Access the ILOM prompt.
See "Connecting to the Service Processor" on page
2. Use the ILOM commands to change the POST parameters.
Refer to Component Fault on page 35
their values.
The set /SYS keyswitch_state command sets the virtual keyswitch
parameter. For example:
-> set /SYS keyswitch_state=Diag
Set 'keyswitch_state' to 'Diag'
To change individual POST parameters, you must first set the keyswitch_state
parameter to normal. For example:
-> set /SYS keyswitch_state=Normal
Set 'ketswitch_state' to 'Normal'
-> set /HOST/diag property=Min
Values Description
POST output displays all test and informational
normal
messages.
POST displays all test, informational, and some
max
debugging messages.
25.
for a list of ILOM POST parameters and
Managing Faults 31