Configuration
Four CMP/memory pairs
(full configurations)
Related Information
"CMP and Memory Module Device Identifiers" on page 107
■
"Performing Node Reconfiguration" on page 159
■
Servicing FB-DIMMs
"Remove FB-DIMMs" on page 108
■
"Install FB-DIMMs" on page 109
■
"Verify FB-DIMM Replacement" on page 110
■
"Add FB-DIMMs" on page 113
■
"FB-DIMM Configuration" on page 113
■
"FB-DIMM Device Identifiers" on page 116
■
"FB-DIMM Fault Button Locations" on page 117
■
▼ Remove FB-DIMMs
Before you begin, complete these tasks:
Read the section,
■
Power off the server, using one of the methods described in the section,
■
Off the System" on page
"Extend the Server to the Maintenance Position" on page 70
■
"Perform Electrostatic Discharge – Antistatic Prevention Measures" on page 73
■
"Remove the Top Cover" on page 73
■
"Remove a CMP/Memory Module" on page 104
■
Do the following:
1. If you are removing a faulty FB-DIMM, determine which FB-DIMM you want
to remove.
108
SPARC Enterprise T5440 Server Service Manual • June 2011
CMP3
CMP1
MEM3
MEM1
X
X
"Safety Information" on page
67.
CMP2
CMP0
MEM2
MEM0
X
X
63.
"Powering