2. Install the two No. 2 Phillips screws.
3. Plug the front control panel connector into the front I/O board.
4. Plug the front control panel connector into J9901 on the motherboard.
Next Steps
"Install the Fan Tray Carriage" on page 134
■
"Install a Fan Tray" on page 88
■
"Install the Top Cover" on page 154
■
"Install the Server Into the Rack" on page 154
■
"Connect the Power Cords to the Server" on page 157
■
"Power On the Server" on page 157
■
Servicing the Front I/O Board
The front I/O board contains two USB connectors. You must remove the front control
panel to service the front I/O board.
This topic includes the following:
"Remove the Front I/O Board" on page 150
■
"Install the Front I/O Board" on page 151
■
Related Information
"Infrastructure Boards and Cables" on page 1
■
"Front Panel Diagram" on page 3
■
"Servicing the Front Control Panel" on page 148
■
▼ Remove the Front I/O Board
Before you begin, complete these tasks:
Read the section,
■
Power off the server, using one of the methods described in the section,
■
Off the System" on page
"Disconnect Power Cords From the Server" on page 68
■
150
SPARC Enterprise T5440 Server Service Manual • June 2011
"Safety Information" on page
67.
63.
"Powering