Post Parameters - Fujitsu SPARC Enterprise T5440 Service Manual

POST Parameters

The server can be configured for normal, extensive, or no POST execution. You can
also control the level of tests that run, the amount of POST output that is displayed,
and which reset events trigger POST by using ILOM command variables.
The keyswitch_state parameter, when set to diag, overrides all the other ILOM
POST variables.
The following table lists the ILOM variables used to configure POST.
Management Flowchart" on page 23
Parameter
keyswitch_mode
diag_mode
diag_level
diag_trigger
diag_verbosity
30 SPARC Enterprise T5440 Server Service Manual • June 2011
shows how the variables work together.
Values Description
The system can power on and run POST (based
normal
on the other parameter settings). For details see
FIGURE: Flowchart of Variables for POST
Configuration on page
overrides all other commands.
The system runs POST based on predetermined
diag
settings.
The system cannot power on.
stby
The system can power on and run POST, but no
locked
flash updates can be made.
POST does not run.
off
Runs POST according to diag_level value.
normal
Runs POST with preset values for diag_level
service
and diag_verbosity.
If diag_mode = normal, runs all the minimum
max
tests plus extensive processor and memory tests.
If diag_mode = normal, runs minimum set of
min
tests.
Does not run POST on reset.
none
Runs POST upon user initiated resets.
user_reset
Only runs POST for the first power on. This
power_on_reset
option is the default.
Runs POST if fatal errors are detected.
error_reset
Runs POST after any reset.
all_resets
No POST output is displayed.
none
POST output displays functional tests with a
min
banner and pinwheel.
"POST Fault
23. This parameter